CoolSculpting CoolAdvantage Plus

FDA-cleared fat freezing with CoolAdvantage Plus applicators. A single session reduces the treated fat layer by 20-25% through controlled cooling to -11°C, with no needles, no anaesthesia, and no downtime. VESUNA MED physicians oversee all CoolSculpting treatments.

CoolSculpting at VESUNA uses the CoolAdvantage Plus applicator system, an evolution over the original CoolSculpting technology that delivers the same controlled cryolipolysis in a shorter 35-minute cycle compared to the earlier 60-minute protocol. The CoolAdvantage cup design draws tissue into the applicator more comfortably and treats a larger surface area per session, making multi-area appointments more efficient. The science behind the treatment is straightforward: fat cells (adipocytes) undergo apoptosis at temperatures between -9°C and -11°C, while the surrounding skin, nerves, and muscle tissue remain unaffected. During the session, a gel pad protects the skin, and the applicator cools the tissue to the target temperature for 35 minutes. In the weeks following treatment, the body's lymphatic system gradually clears the crystallised fat cells, with the final reduction of 20-25% of the treated layer visible at 8 to 12 weeks post-treatment. VESUNA MED physicians conduct a body assessment before treatment to map the target areas, select appropriate applicator heads (abdomen, flanks, inner thighs, double chin, and others are all compatible), and establish whether a single session or a staged programme is more appropriate. The institute's device fleet allows simultaneous dual-sculpting — treating two areas at once with two applicator heads — to halve the total session time for patients targeting multiple zones. Recovery after CoolSculpting is minimal. Treated areas are typically firm and temporarily numb for several days, with mild redness and tingling as sensation returns. There is no restriction on exercise or daily activity. Patients planning to address fat reduction alongside muscle definition are often advised to sequence CoolSculpting with EMSCULPT: fat first, then muscle-building once the treated area has cleared.